Search results

We converted to the eg22 on three trucks they will operate up to 18 bulbs with no problem. I carry an.extra flasher on each vehicle have not changed any since install. Amazon had them half the price as napa.

Anyone know if this is available at NAPA or elsewhere Cold Start Relay above flasher unit Thanks Scott

My opinion this was a great event awesome people. My only suggestion get 2 young lads put them in a golf cart have them haul parts out to the parking lots and collect tips I would venture to say they would make good money in tips.

Good luck enjoy workin on it

We had nothing but 5 tons xm 656 757 Banderhoff Kaserne 1974 1979

level ground maybe up a hill and put on the brakes to hold the grinder' No Way . We moved one last winter some snot on the gravel road hooked a 6 in the front with 2 chokers and 2 3/4 chains when it hit the incline about 30 degrees got a voice from above stick the D8 behind as backup

855 green tip ammo if my memory is close to right

Geeeeeez you learn somethin new everyday Thank you for the reply never even thought of that stared at it a good 20 minutes on the work bench .Have to replace fitting on fire wall inside flare is split and leaking.

Take every cable you have from the batteries to the starter clean them with a small wire brush even the short cable at the starter to the solenoid . Check the cannon plug at the control box also the battery switch wire that runs from the control box to the battery switch. Stupid way get the...

I wanted to replace the oil line from block to gauge fitting always leaked at the bulkhead fitting on firewall. On the other side t fitting with starter lockout switch never knew it was there how does this function is wire 93 go to ground in the protective control box and works on not enough oil...

Ballast resistor a must where they mounted it was stupid we had the 880s always deadlined waiting on resistors good luck with it

Whats on the other bumperette???????

Sussex Show 2016 NJ, April 16th and 17th Anyone heard of a date this year for the show at the fair grounds.

Have to go to NAPA for parts does anyone know if there is a part number for the filter mine is on top by governor older model. If not I will go to Cummins dealer thanks Scott

Mine had 2 " on the front no problems back in the day we could not get the 1 3/4 we used the rear cylinders. If it is on one side maybe a slight pull but doubt it? See who else chimes in

What I did was cut the back cushion off the back at the base where it bends in, then moved the shock mount upper stop mounted inside of seat back and up a couple of inches.Made a spacer to go under spring at the base. Fussed around with the steering column went toward the windshield 3 inches and...

809 fan hub seal part# Im posting part # seal for the rear hub fan NAPA 17387 cost $ 9.00 Scott Also note when putting washer on shaft it does have a flat spot inside that has to set on flat of hub shaft. Took 15 minutes to realize that could not get the cotter pin in but no one saw that...

Also tore the fan hub apart goin to install new races and bearings anyone know if the rear seal is available at NAPA Thanks Scott

Tore it all apart today bolts were completely rusted even in block got down to the pump mounting plate that mounts to block. Does anyone know if this mounting plate has a flange that sits inside of block? Soaked it down and tapped all around but would not break loose let it soak overnight. Im...

Leak started where the fan hub mounts to the timing cover into the front timing cover. The adjustment bolt for the fan hub was missing and one of the hub bolts worked out and is rusted in place. Put a wrench on it would not move so im going to pull the radiator and replace all the belts and pump...