Search results

quick question > tool carrier You need the small Caltrans plow on the front We always called them a pioneer rack

Have you contacted gulfway?

The timbren axle less suspension is a interesting suspension but the trailer frame is not rigid enough and will require a subframe

Lowest bid from u ship

The navy trucks started out marine corp semi gloss

Cruise king makes one specifically for diesel trucks

They start at $82,000

It is best to pull the current filters and cross reference them to your favorite brand

Check everything Don't forget the brakes Wheel bearings are a big item

It's a 12hp engine dating from the early 60's according to what I have found

I looks like the engine could be a kohler k series

Have you contacted Novak for there advice?

I see

Did I miss something

I high school I had a 1977 blazer, commercial spec, that developed a crack in the frame by the power steering box

3/4 ton rated truck from an era before military or most of the country new what today's freeway speeds are

The floor boards run parallel to the truck frame. The floor crossmember run parallel to the axle. Each floor crossmember needs to supported solidly, this is usually accomplished by the box subframe, a wood strip and the truck frame. If the floor crossmembers are not properly supported the...

Several trailer manufacturers that I was able to look up there information, specify that the tongue must be within 1" of level with the trailer and towing vehicle fully loaded. Each of the 3/4 ton trailer versions were specifically mated to a tow vehicle In there design phase. By doing this...

To support the box. You need to support the floor of the box with the frame.

If you don't cut the rear you will meet to extend the frame to the rear of the box and move the lights and add a dot bumper