Search results

Thanks for all the replies. These ones I have say 12 volts.. so I'm going to use the resistors and hook them up power to frame ground.

I have some 12 volt LED flood lights I would like to hook up to my 24 volt MEP802. Can I hook them up to a single battery and ground to the same battery? The generator uses two 12 volt batteries in series. Can I run wires to one of these both ground and positive to run some 12 volt lights...

Thanks ! The 1/2" NPT to barb and some 1/2" fuel line worked perfect. Annual Hurricane maintenance time.

The oil drain on the mep802 has a threaded plug that uses a 3/8" socket drive. Is there a threaded fitting that has a barb so I can drain it using a hose? My Generator is up on a trailer.

The overload error is the one I was getting before I dried out the controls that are behind the gauges with a hair dryer.

Found it: two piece adapters - 3.25" thick - FROM 8x6.5 hub bore 116.1mm with lug nuts treaded 9/16-18 Standard -- TO --> and "this is where you put Your Jeep bolt pattern and thread size"; so pattern is 5x5 and your stud and thread size you need for your wheels. Depending on your jeep wheels...

No that doesn't sound right. Method 1: Adapting from trailer OEM to Jeep or other wheel pattern. (cheepest) I think mine are 3" thick and the vehicle center bore was approx 3" bore, and they are a 2 piece adapter. The adapter is as thick as those trailer studs are long, plus cover the...

It was the whole control area like 69birdman pic's have above that I took a hair dryer to it. The fault was tripping from high humidity. That is if it's running and a humid down pour the machine it hot and runs fine, but when trying to start it it has issues sometimes when humid.

Thanks again for your help !! Where the nest it was OK. The L1 line was chewed and was touching the case. I found it checking continuity from L1 to Ground. I had to remove the bond when checking all the continuity points. Then I put it back when I found the issue. So .. a few weeks back I...

Success !! Thanks everyone !! 120 / 240 Phase-1

Cleaned everything Up.

I found the creature of interest !

Thanks ... I will check the K1 leads today.

The phase-3 vs phase-1 problem was me, I didn't know the phase-3 and phase-1 controlling was the one behind the panel, VS the switch that is on the panel and lets you select phase-1 and phase-3. THanks for your help on that ! Now when I put the switch (behind the panel) on Phase-3 is shows...

Thanks.. that problem has been resolved and I have a new one that is different.

thanks

Thanks ! Hopefully that is my issue!

The switch I am referring to is the one that selects the Phase and legs you want to use. (sorry i don't know it's name). I did look thought he TM's but I didn't see anything that popped out at me. It is this one circled here. (not my gen just example of the switch).

Without the load hooked up the Phase 1 shows no voltage. Without the load hooked up on any the phase 3 setting the gen runs ok and produces power on the phase 3 settings. With the load hooked up the short-circuit light come on as soon as the gen circuit is turned on. I'll go through the TM's...

Could someone please help me on where I should I look to correct his problem? Generator engine MEP802A starts and run fine. With the switch on any of the Phase 3 settings the meter on the unit shows the generator has power, and myself with a multi meter shows it has power BUT when a load is...