Search results

I just got a MEP-831A with less than 15 hours on it. When I run and test from L1 to N it has 120 volts, and from L2 to N has 120 volts, but from L1 to L2 it should have 240 but it's zero volts. I am thinking some wire must have been hooked up wrong, but I'm not sure where would be the most...

Fixed .. Thanks again! I held the "start" position longer than usual for a few times and it reset. Everything is working as it should now. Is the K1 part on the 813A (400hz) the same part as on the 803A? It seems most of the parts on the two units are the same.

Thanks, I'll check this today, and re-test the outlets and see if I can post a video somewhere. The meter does say 240 volts and the Hz is around 60.

Thanks, K1 and pull the top off. I'm in FL but it's 36 out there this morning. There is no power at the outlets, they are DOA also. I downloaded the manuals this morning.

That is the ONLY one I could find. When you use it if you plane the head, you need to also shave the rocker arm bolts since they depend on that head spacing.

I have a MEP 803A, 10kw gen set and it has been running good for about the last 90 hours, had 10 hours when I got it. Today I go to activate the electricity and nothing, no power and that green light did not turn on. I lift the switch to set the "AC circuit interrupter closed" and the green...