Search results

Hi I went out after a couple hours and she started up. She sputtered a bit then killed but started up again and she is running fine. I think maybe she just needed to get fuel back through out the system. Ken

Hi OK here goes. Last week If she sat for a day or two I would have to turn her over several times before she would start then she would be fine the rest of the day. Not knowing The cause I changed the fuel filter. Anyway then she wouldn't start at all. Found that I wasn't getting fuel up to...

Hi Sorry it took me so long to get back on this. The problem ended up being a bad battery. Even though she turned over fast she just wouldn't fire. Put in the new battery and she fired right up. But now if she sites over night I have to crank her over for about ten seconds before she...

I know there has been a lot about this subject but here goes. I started my 1991 and drove it about 50 feet and parked it. The next day I tried to start her and all she would do is turn over fast but fire up. The start light seemed to take longer then usual to go out and I can hear the...

HI Thanks for the help as usual. Ken

HI I see that Autozone carries half shafts for the H1. I would assume they would fit my 1991. They list three part numbers (16058n),(16059n) and (19060n). I need the front left and right shafts. Does someone know which P/N would that be? Thanks for the help. Ken

Can someone tell me where to buy an outer cv boot for my 1991? Thanks Ken

Good day Have a 1991 Humvee 6.2 and I am wondering what these fittings attached to the radiator are for. Thanks Ken

HI The cables are for radios, Ham and AM/FM . I have an antenna on each rear side. I need a grommet with about a 1/2" center hole. I wasn't sure if there was a grommet that the military used. Ken

Hi Has anyone found a source for the rubber grommets that fit into the rear antenna cable holes. there about 1 3/8" in Dia. Thanks Ken

Hi Thanks for the help. Ken

HI I have a 1991 and am looking for new glow plugs. I see on Ebay that the price varies quite a bit. Is there brands that are good and ones to stay away from? Thanks for the help. Ken

Retiredwarhorses OK,Now you have me confused. First are you saying the PCB has nothing to do with the glow plugs? You said the GP controller is on the water crossover. Where is that located? What is the TCU? Sorry for the ingorance. Ken

Hi Here is a picture of what I have which is a PCB as you had mentioned. Ken

Hi When starting her in 50 degree weather she may cycle on and off at idle for 15 minutes before staying off. When it comes to EESS or PCB How can I tell which? Ken

Hi How long should the glow plugs keep cycling when you start the engine? 1991 Humvee. Thanks Ken

Good day Has anyone added or replaced the pop rivets in the rubber seal around their soft doors. In some areas the seal rotates to the outside causing a poor seal. I have tried to drill into the rod to add pop rivets with no luck. It acts like the rod is hardened steel. I also have tried to...

Good day I built an overhead console for my radio and thought I would post some pics. Made of plywood and hardboard with aluminum edges. Ken

Hi Thought I would try to send a picture of how mounted my disconnect switch. As I said this is in the base of the pass. seat.