Search results

You need it hooked up to the battery for it to work.

Gov planet sites like to use starting fluid which is a no no.

Its an H turret. Two guys in Texas has them, one is mounted. I found one at Paul Mollers place.....only the big parts, and sold it.

And...the early and late 12 bolt and even spaced 24 bolt wheel uses the same valve stem assembly. Odd spaced 24 bolt uses a different valve stem.

Hmmwv wheels wont fit M101A1....has the wrong axle / drums. Now a M101A2 can be used.....it has the proper 8 lug pattern. Some guys used a wheel spacer to bring the hmmwv wheels out a little to clear cable and or structure.

Get the early, or late 12 bolt or 24 bolt wheels with the one piece runflat/beadlocks, and then your ok. 8 bolt wheels and 36" R/T's should be in a land fill, or something. I use those 8 bolters and bias tires on trucks in the yard to roll around, and do paint work on, so good tires / wheels...

Disconnect batteries when doing most electrical work.

Soft top trucks have a rubber oval with three contacts visible when you lower W/S frame. Lower it again and clean and inspect them. Also one would have 24 vdc at it.

In the parts manual, it shows A1's to have front high back seats.

The outer is hardened, inner is soft steel.

Windshield bezels are M1025/6 series...thin glass. Has the screws in rocker panels holding the internal thin armor plates.

I have a Mount and matching unit with wiring for that system. Going to Lodi next week.

Same part.

1982 ? No such Hmmwv. That fuel panel is not factory. Somebody in a factory might of did it. Most rivnuts in the hmmwv are steel. If installing new ones....after holes drilled, apply sealant around rivnut, put in hole then squeeze it in.

I have new ones for $ 50

Harness if found are around $ 1500 or more. You'll need a trans X member, drive shafts, shifter, trans / T/C lock lights, New differential yokes.

I have some spare metal I can trace a panel onto. I also have late style sending units.

Red gear will have a 36 on it Orange gear is for 2.56 ratio.

I have a demilled BFT screen that I took apart and added a police 12.1" lcd monitor to. I'm going to do another soon, and will sell one. In F/S section

On a motor from the past.....it leaked in the valley under the pump....was the plunger o-ring. I have lots a new -3 valves available, and maybe a new 4879 pump.