Search results

Were did you get the little vents, I need some of them. Thanks,

If your going to switch fluid you need to use Dextron III.

ntxcop, Thanks and hope your truck turns out nice also.

Sweet!!!:drool:

That does not look like the one that is on my trucks.

Looks great and good of them!!! I know hot, we are going to a display show today with the m936 and it is forecast to be 118 here.

Yes you can cap the Emergency glad Hand off. I think it is 1/2 pipe tread.

Have safe trip!!! Road trip:driver:

Very nice fab work!!!! I just weld on steel buildings mostly.

I am redoing a deuce and I used bed liner on the floor of the deuce. I used Raptor bed liner, it is a two part system and you can tint it. A kit with 4 bottles and spray gun runs about $120 and I only used two for the deuce cab. The kit is the size for a long bed pickup. I think I am going to...

Not close to my trucks, but it is a lot more then 28". Will check later. 36" to the bottom of my M923A1.

I had some coolant on the drivers side floor board some time back and I looked and looked and it turn out to be from the oil cooler hose on the left side of the motor. It was the little hose and a hose clamp had come lose and it was spraying back on the fire way.

Welcome to the Site!!!!

I lost one and I used Loc-tite and I drilled and tapped for a set screw in the housing.

You may need a new gasket for the oil filter and the sending unit is on the right side at the back, low above the starter. Looking at the TM's is a great way to learn about your truck. They are free to down load here on SS.

Nice job!!! I am working on one also, so I know your pain.

If the flat tire is on the front I would move it to the rear for the drive home. The tires get driven on when they are flat and my of sit flat for a long time, just need to be on the safe side with the tires on the front. Have a fun and safe trip home!!!!

Sounds good!! I was thinking of using 90-140w.

Seal at top of door, it goes in before the window then you have to push like (*(*(^^% to get the window in. But it will go. When you roll the window up the seal will move right.

That is a lot of info. Thanks, good read. I use the Valvoline High Performance 80W-90.