Search results

Actually, ream the hole for a tapered finished. Look at this about 3/4 down the page for the right reamer. The hole is drilled accordingly. Products If the hole is not tapered is a good chance that the threaded fitting wont tighten and seal properly.

For a little cartooni style info: Steel Soldiers :: Military Vehicles Supersite

Two choices, forward three of rear three cylinders, both sets monitored here. Remember to taper the bore for the pipe threads.

Yes. The resistor is 33 Ohms (dash light dimmer function) about 10W and the CB is rated 15 amps...

Here you go (wiring diagram). On plastic housings, both mounting screws must be grounded.

Nice, nothing like a crane. :-) For all your added extras for that truck, go here: Steel Soldiers :: Military Vehicles Supersite

Mike, how's this?

...or use properly rated switches to place batteries in parallel when using the dump and back to series config when charging.

Look up "battery equalizer"... OPCOM has experience here. Also, check out batteries that can handle deep discharge better than "starting " types, Optima yellow or blue top.

As a warning device, the light is a bit iffy in MHO, sunlight will easily drown it (like the turn signal indicator by the steering wheel, which is impossible to see when the sun hits it). My solution is to use a turn signal flasher unit to run the buzzer. The intermittent buzzer sound is much...

Yes, thanks Gerhard! The Army does have a "textbook" on the general subject of automotive principles, TM 9-8000, so for illustrations and further descriptions, check it out (I'm not speaking to you G, but to rest of the troops)...

A couple of options...been using the studs as steps since I flipped the hubs and it works great. The '69 xm757/m656 came from factory with these (image #2).

Like the wide lane marked for bicycles. Traveled a lot of those back in the early sixties....including Holland.

...and the strands are tinned. The jacket is "hypalon". 14 or 16 ga is fine for the gauges.

Thanks! Not much chance they would have saved the original bed, is there? Do you have the spec on those tires?

The nature of the projects take on another color when the basic vehicle is up and running...:-)

Welcome to the site! Let me know what you need. Love working on my 757. What did you use as base vehicle, M656 and pictures are a must? :-)

Heater controls.

Question, would a "new" carb from Saturn or other dealers be considered fresh or will they need to be rebuilt? Can't find rebuild kits anywhere and may have to save up for a new carb.... TIA

I put mine on an aluminum plate....