Search results

Nice vid Jim!

All, Went out to the general area we will be in last weekend. Could not have asked for any better weather! High 60's daytime, low 50's to high 40's at night, no wind! Man, if this is any indication of what we are to expect, it will be an AWSOME weekend! I have some pics, but the camera is going...

It actually had 10 bids but didn't meet the reserve. If it were me, i'd check the ownership. No too many in private posession and just 'cause ha says he owns it...

Unless yours is already converted to the air side, don't waste your time with a new switch. Buy the Saturn upgrade and put it on the air side. Saturn Surplus http://saturnsurplus.com/m35/5025.jpg

Did you try tightening them? The w/p is eccentric, loosen the 3/8 capscrews around the pump and give it a turn. The pump seal ring MIGHT leak after the adjustment though.

There is a Cummins parts manual in the TM section for the NHC. I think it is on the 1st page. It has all the Cummins part numbers, old ones, but the parts goofs SHOULD be able to supersede an old number to a new one. Some of the hard parts still have the original...

What kind of RPM are you at when you are doing 35?

There are around 10 at the Museum as well as 5 or so 725's

The LBZ doesn't have the injector issues the LLY had. As for the DT vs Cummins, have you driven the two? The B will run circles around the DT. I have had both on the dyno and the B is a much harder running engine and has better holding power. The DT makes OK power but falls off very fast. If...

This has been covered many, MANY times. A search will yield oodles of hits. In a nutshell, read the label, if it is yellow metal compatable, you are good to go. IDK if i'd put 30wt motor oil in a vehicle that has the 26k capabilities, it might be a tad much for the lube.

I like that 548 in the background! Nice job on the 37 though!

Try here for the TMs, Steel Soldiers :: Military Vehicles Supersite

Zinc and phosphorus have been added to lube oil for a long time. Before there were valve seals on modern diesel engines, oil was drawn past the guides and burned. That is what some of the PM that comes out the tail pipe was and one of the reasons for using specially formulated oils in new...

Try places like this, Fleet Truck Parts: Your Trusted Fleet Truck Parts Supplier

WADDA YOU GONNA DO WITH THAT??? :p

I'll probably do the ring at the Museum, there are forklifts there. Your boots OK or do they need replacement too? I just gave my last one to a guy from here, and haven't heard from him on the replacement so I gotta get a few more. I can get some for you at the same time. I think I'm gonna go...

Good things come to those who wait!! Besides, I need to do some axle boots and a ring mount and a new top on my turd before we go aua

The intake is already an air to water cooler. That's what that big 'ol log above the exhaust manifold is.

Ya know, this thread reminds me....it is SUPPOSED to start raining pitch forks again tonite, better go go cover that bad boy back up. The cover is still in the flower bed from the first start after the rains we had a few weeks ago:roll:

It looks like the rear half. The box on the bottom side is located in front of the rear x member.