Search results

TOBASH, I should have titled it "disassembled, cleaned, inspected, repacked, new boots and reassembly" of half shaft... I fortunately did not need to replace anything other than grease and boots. The ball bearings, star and cage were all in good condition. See full write up under topic "HMMWV...

Today was a good tinker day, disassembled a half shaft to clean, inspect, repack and put new boots on. Lot of videos on how to remove half shaft so I wont get into that. Once I removed the half shaft I placed it in a vice. I removed the clamps on the boots (small screw driver works good)...

Rebuilt my spare half shaft, write up and some pics in half shaft topic. Really was not hard at all, be sure to wear dirty clothes ,,, if not they will be dirty when you finish.

Several guys are saying they have taken the half shaft apart and it's "time consuming but not difficult" but no one gives a play by play. I'm trying to break down an extra half shaft to build it up as a spare, inspect, new boots, fresh grease, fresh paint. The inboard side has a retainer ring...

Just felt like getting soaked with sweat so I rotated my tires this afternoon in 86 deg and 68% humidity. It worked,,,I was soaked. :whistle:

Couple pictures from yesterday. Queen of Peace Cemetery, services with a small display. My HMMWV proudly flying her flags. Cocoa, Fl Parade line up and display after.

Hold downs are internal, I just used some #10 bolts, drilled thru the plywood and put washers and nuts under plywood. Plywood comes out easy, just mark where you plan to put ammo can and drill away. 24v comes hot off batteries to master pwr switch then to fuse block and then to USB ect... I pwr...

ChiefB Here is how I hooked my ammo box with USB, voltage and cig lighter spot. In the bottom of ammo box I put a 24-12volt transformer and fuse block, on top of these items I built a false bottom with 2 small "eye" hooks in opposite corners to lift false bottom for access to electronics. On top...

:roll:

Drove mine 3+ hours each way to a "Touch a Truck" event that also collected canned food for the "Harry Chapin Food Bank". This was their 3rd annual event (I've been to each one), good showing of support from the community.

Thanks

Took my unloader apart, cleaned and replaced parts, builds air good now. My problem was she would build air after first start then when that air was done so was she, would not build air again. First I thought (hoped) it was the governor but after swapping in a new governor same problem. Next was...

Started taking my unloader apart today to fix my air (not building) issue, here's what I found upon removing unloader section. I'd say the gasket is shot and she's a little dirty... Cleaned her up today, will try to do some more cleaning/inspecting tomorrow, replace parts as needed, new gasket...

Where would I install the resistor ? I think I have a LED compatible flasher unit some where in my spare parts supply but I'd like to try the resistor first. Thanks for the help

Stumped, I just installed LED brake and turn signals in my '86 M998 but,,, when I have my head lights on the turn signals don't work. With headlights off everything works perfectly. I replaced the bulb in turn signal switch with an LED, I have LED marker lights, LED headlights, LED brake and...

Welcome from South Florida

Welcome to the Green Madness, like potato chips,,,you can't have just 1.

Transfer case data tag Mine was painted over.

Welcome from South Florida, my first was a M923A2, still have her, great truck just a bit on the large size.

Welcome from South Florida