Search results

Yes I did finally get the items together I have my m1009 done and love it I converted to kero (was informed these heaters work better with kero) like the deuce and five ton guys did, runs way better starts better and no smoke I will try to get some pics of what I did but basically fuel jerry can...

if you have thin wall sockets that will help as well

what I did was get a half inch drive impact some swivel joints and went from the top down between the bumper and the tailgate had the rear bumper off in 15 minutes. You may have to go down to 3/8 drive with a breaker bar for some of the bolts though. I also soaked the nuts the day before with...

Ya that or you fry half your under dash wires like me because I put it off to long. I think everyone who buys one of these trucks should do the mod as soon as they can would have save me a lot of work!

would the tailgate hit the bumper?

had similar issue as you I had both alts rebuilt by a reputable shop told them I WANT everything inside replaced well got them back and yep both gen lights on dim now well got bored and ripped one of the alts down my self and found out they did not change the diode trio or the voltage regulator...

I just asked for the ones for a 27si alt 12 volt 100 amp

look at the post I just made gen lights I had similar to what you have but all has been fine since I did what I did Look at my post.

well both alts rebuilt (ha ha right) was 125.00 considering that they where told to replace everything except the stator, case half's and the armature I was not happy to find out that they did not do that. i asked them to do this because of what I read on here about the diode trio causing gen...

i use it in everything I have. This is just my opinion but i have increased my fuel economy reduced smog emissions, removed a valve tap, removed what looked like tar from and old engine on and on I swear by it. I have a mercury marauder and every fluid received sea foam when i bought it then a...

Since alot of people seem to be encountering this I will tell you what finally did the fix for me and only cost 25.00. First I had the Alternators rebuilt helped some but problem still there fan on high etc. Well got bored yesterday and pulled them out and tore them down found out that the shop...

yep for the fire putter outer

use a rubber chair leg protector fits great!

draining the tank is what its for. the stock fuel line has a t fitting up by the pass side tire area just under the flap this is where the arctic heaters connect to.

found this site today kinda cool looking models a bit on the high end but still cool looking http://www.panzershop.cz/inshop/scripts/price_list.asp?Level=300

Thanks for doing this kinda cool to get some more history on my truck a. Serial Number - 1G8ED18J6GF124918 b. Registration Number - CU3535 c. NSN 2320010907635 d. Bought in Denver co e. No bumper number just says WY ARNG M1009 cucv blazer

plenty of pics on here just look up arctic or winter heater you ll find a lot of good pics. sad to say I can not get a hold of my contact as of now so there will be a delay. Yes it might be alot of cash but all you pay for is the kit and shipping mean while I have to drive over 5 hours round...

where on the frame do they go? any more info?

Yep thats about how I do it not really hard job just not fun on the floor! I did follow the manual first but after that not any more as the manual has a few steps you dont really need to do.

Pisses me off that they do this to old MV. I was in the NV national guard for a few years and one job I got was to load some of the old manual tranny dueces litterally drove them on the truck to take to the range nothing wrong with them except they had a manual trans thats it! what the heck the...