• Steel Soldiers now has a few new forums, read more about it at: New Munitions Forums!

  • Microsoft MSN, Live, Hotmail, Outlook email users may not be receiving emails. We are working to resolve this issue. Please add support@steelsoldiers.com to your trusted contacts.

Search results

  1. D

    Test run

    Maybe check for loose ubolts on the axle. Broken or loose suspension components(leafs, hangers, etc). I also went back and seen you mention hydraulic steering.(unless I’m confusing you with someone else). Maybe you have some leaky valving going on and pressure is bleeding by causing the...
  2. D

    Test run

    I only removed my center floor that the shifter comes up through. If you can get to your top cover of the trans that’s all you need. Then remove the small jackshaft between the trans and the TC. You’ll need an impact and I think a 1.5” socket to remove the yoke. Remove the rear seal plate, and...
  3. D

    UORVA 250/300HP upgrade kits

    This is a myth. Extra tubing cannot be blamed for lag. Lag is 99% of the time the specs of the turbo compared to the specs of an engine. A few extra feet of piping is not to blame. IMO
  4. D

    Test run

    Sounds like maybe your 2-3 shift synchro may be worn or wearing out causing hard shifts. Although the 2-3 synchro is serviceable without dropping the trans, it is located at the “end” of the main shaft when tearing down in a press. Ive had my main shaft out to make a repair, it wasn’t to bad...
  5. D

    UORVA 250/300HP upgrade kits

    IMO any intercooler will help; any lowering of the intake temps is a PLUS
  6. D

    $4 a gallon!

    $4.60 today in Orrville Ohio I started making/mixing my own fuel a few weeks ago. 60% waste oil 30% diesel fuel 10% unleaded gas Mix and then filter to 1 micron. Then straight into the fuel tank! So to make a total of 5gals, it would be 3gal of waste oil, 1.5gal of diesel fuel, and 0.5gal of...
  7. D

    Help with side mirrors…

    Thanks! Piece of cake now that I can “see” it.
  8. D

    Help with side mirrors…

    Thanks, I can make one at work tomorrow! I take it that same bracket on the passenger side is the same, if so I’ll copy that. I also assume the passenger side mounts to roughly the same location on the cowl as the driver side?
  9. D

    Help with side mirrors…

    I don’t have this mount on my truck, circled below… there is one attached to the passenger side mirror I found. But nothing attached on the driver side mirror. So that type apparently have never been mounted on mine???
  10. D

    Help with side mirrors…

    Since I bought my truck mirrors have allows been on my mind because of what was tossed in the bed when I got it. Well today I finally got to digging them out of the bed. I have taken some pictures. Currently my truck only has a drivers side “small” mirror and nothing on the passenger side. What...
  11. D

    Found and bought a bobber kit

    Where did you head to? What all was or wasn’t included, and for how much?!?
  12. D

    Findlay Ohio 2022 show, Sell, Trade, Wanted List/ May19-22

    Looking for (4) MRAP wheels for a deuce project! No ctis needed. ‘Mise well put a feeler out now!
  13. D

    Is it true of all the slews of bugs that the deuce has?

    I bought a neglected deuce knowing it was neglected. But, part of what I enjoy is wrenching on it just as much as driving it. It was cheap and that’s what drew me in. Some parts aren’t cheap, others are. I have no rush, and chipping away at them slowly. In my opinion, once I got mine on the...
  14. D

    Utah Introduces Bill to Allow Exemption for Display of License Plates on Military Vehicles

    If I read correctly Ohio also allows this. We can remove and keep our plates in the vehicle, while only painting/stenciling the tag number on the vehicle. Then it appears as “original” military tagging with no need to display the actual plate
  15. D

    FL Is Hagerty schizophrenic?

    I just insured my deuce yesterday. Our private insurance guy couldn’t cover it but he is also a writer for Hagerty. $180 a year, which beat a Hagerty rep by $26 and I have slightly better coverage, which is comical since it’s carried through Hagerty. No driving restrictions, or pictures of a...
  16. D

    What did you do to your deuce this week?

    I really have to unscrew my valve to get mine going. Then I can usually back it down a bit
  17. D

    Title discrepancy? Or confusion?

    So you’re saying they needed/were asking for 17 digits?
  18. D

    Title discrepancy? Or confusion?

    Here in Ohio it’s like $16 for a “new” title, and I think the same price to change misinformation. I just had a new title printed a few weeks ago for a different vehicle Good Luck!
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website like our supporting vendors. Their ads help keep Steel Soldiers going. Please consider disabling your ad blockers for the site. Thanks!

I've Disabled AdBlock
No Thanks