Search results

Not a chance, they all go back to Oshkosh now for rebuilds, I'm told even the wrecked ones.

Remove CARC with det cord . . . My civilian '93 Hummer was factory painted with CARC, I love the stuff, almost as tough as powder paint. For small spots by hand I used a good filter face mask, no not the paper type. I agree a pressure fed respirator system is a must. Fresh air mask gets it's...

I purchased an NOS carb on eBay a few years back for $75.00.

I am happy to give rides in it however, and I'll happily pay for all the Diesel! :driver: Hopefully my new bed sides will be done by then, they are getting powder paint epoxy primer and 383 green top coat. The 4 color camo will have to wait 'till spring/summer.

I have a funny story to relate to that (we think its funny anyway). Years ago our local MV club President wanted to come up with ways to make the club some more revenues at events. He came up with an idea, we would charge $5.00 a head to drive my tank over a car. Some background: I had...

Answer tomorrow . . .

Mark (Jinx) and I were planning to meet at 0930 just south of Bellevue in order to arrive slightly before 1100. Unless my truck breaks or a major cats-ass-trophy happens, I'll be there.[thumbzup]

The fastest I've entered the water in a Stalwart was about 25 MPH, it was fun to say the least. I believe it was some Germans that drove one off a 20' high jetty, with the cargo cover fitted it came right back up after being FULLY submerged. They will swim with the full 5.5 tons if you don't...

Ttt

If you can find 21" wheels, HEMTT wheels are 20" dia.

If that's the case, you can check them if you like, I'll feed you beer to parch your thirst, there are a LOT of nuts ;)

I was kidding, someone your size it's no problem, at 240 I don't have a problem although it would have been easier when I was 370. It only takes about 180 lbs of force on the handle of my 42" long torque wrench to make 600.

3500 lb.ft. is too much, think 600 lb ft with a TORQUE WRENCH set at 600. Cheater bars are only for loosening bolts you know.

Don't get too cocky, I might "let" you torque my front 2 axles worth of lugnuts WITHOUT a torque multiplier. :)

Lift things . . . hmmm . . . with what? :D

Yes, and it was written by Bjorn, AKA Cranetruck, who posted above you.

They have a gear set inside that trades additional rotational energy and trades it for torque. Some have a 1:3 input to output ratio and I've seen some as high as 1:9. You can also stack them and multiply further. I just bought one with a 1: 3 ratio so I can torque my output yoke nut on the...

Myself, I like DOT 5.

Sick and STUPID, thanks for the political statement . . . NOT!

I'll bring my big flame wrench and we can cut the frame at the firewall. :twisted: