Search results

Hey Tim, If all holds good, scheduled off on 14 April and back to the grindstone 9 May. If I remember correctly, that is about the time we usually have the rally... 4X

I'm in if I'm off...you know how that works...would finally like to make one of them!

There is your problem right there WM, you need that 1.21 gigawatts to make it work...fat lady sings :naner::naner::naner:

Make sure you check the metal below the hoses you are using periodically. The polyester outer covers like to hold water/moisture and cause rust.

Welcome from Lake Chuck!

Nice looking steed there! Have FUN!

Welcome from Lake Chuck, WhiskeyDelta There is no known cure for Green Iron disease, well, other than more Green Iron.:mrgreen:

Keep up the good work! This will take some time..... Subbed

Rubber hose for a very temp repair and Replace with new steel line soonest. The rubber will slip off the ends of the lines and dump all of your trans fluid and then you will have fried trans... Try Summit Racing...

I changed the gears from 4.56 to 4.10 on my M1008. Did not loose towing and acceleration is about the same. If you have a reason to change, I'd say go ahead. Mine had loose internals in the front and decided to do the swap when I rebuilt it. Cost was about $1100 each end but included everything...

Welcome to SS Red Stick! 1. What did you get? It's 2016 - no photos, video only! 2. There is no cure for Green Iron, well, other than more Green Iron... Lake Chuck

https://www.fcc.gov/general/citizens-band-cb-service The above address should give you answers to the freqs and requirements of the radios.

Actually has used this method but used 3/8 x 7" bolts as it gives you a little more clearance to work. Wear gloves as there are sharp little buggers waiting to get knuckles...

The M1008 will fit the largest Uhaul car trailer they have, with 4-6 inches to spare, with stock tires. Retrieved my M1008 from San Antonio on one, but behind a 2500HD... Keep looking, you will find one!

Looks Good! Subbed

Good Luck and Happy Motoring! Do keep the Advil close by!!

Subbed

Have you checked the fluid level in the XFer?

They like to be used! Nothing is more harmful than not using a piece of equipment. If it solves the scraping/rattle for a very short while and you know you just zapped it full of grease, you can now point to it as the culprit OR to start looking at other things.

Try shooting some grease in the u-joint and giving it a try and see if the noise goes away or changes.