Search results

I will give him [thumbzup] for at least having safety chains. Although it seems he hooked them to the ball mount. :-(

They installed valves so that oil samples could be taken.

That's pretty much what I have found to be true with my deuce also. Although we don't near as cold as some parts of the country. gem1410, nice truck. Glad all went well on the recovery.

Congratulations Mike. Nice work. [thumbzup]

FYI, there is a member that has the decon container for sale in the "classified-other" section.

Yes you can. You might want to go just a little easier on the throttle sense you would have double the torque going to just the rear axle. I do this in my pickup when parking my travel trailer.

Glad to hear you had a uneventful recovery. It's been said a million times before but keep a close eye on the brake fluid level in the master cylinder and check around the wheel cylinder area frequently for signs of leaking. Be safe and have fun.

From TM 9-2320-361-10 2-15. COLD WEATHER STARTING (BELOW +20°F) (-6.7°C) Do not press start button for more than 10 seconds at any time or with headlight on. If engine does not start in 10 seconds, wait 10 top 15 seconds before pressing start button again. Failure to do this may result in...

Great point. I cleaned the groove and boot thoroughly with brake kleen and "clean" rags. This made it very easy to install the inner clamp without the boot popping off.

I did my adjustment with the tire off. The important thing is that the hub is turning when you are doing the bearing torque. As AceHigh stated you need to check the hub temps after a short drive. I have to hubs on the rear running hot and I used the exact same procedure for all 6 hubs.

Good luck and remember we are all counting on you.

Per TM 9-2320-361-20, Sec 7-6, step #8, There is no gasket or sealant between the the two. Mine had no gasket or evidence of sealant when I disassembled it. Both are the same per TM 9-2320-361-20, sec 9-5, step 2 "2. Turn wheel, tighten inner adjusting nut (3) 50 lb-ft (68 NŽm), then back off...

Explained here http://www.steelsoldiers.com/ss-main-site-improvements-updates-suggestions/61511-out-old-new.html

Know wonder I like my deuce so much. :grin:

I would give the following a call. Although they don't list any intake flame heater parts they just might have them available anyway. Worth a shot. Military vehicles for sale, surplus military vehicles for sale ? Memphis Equipment M35 For Sale. Deuces for Sale Turbo Diesel, Army Trucks...

That's really looking nice. Great work. [thumbzup]

I just went through the rebuild process and chose to keep the original hard lines after inspecting the outside for rust / corrosion.

A nice single malt scotch makes a pretty good payment to. :)

Also seem to have them here. Brake Light Air Operated Switch Upgrade Kit For M35A2, 12255668

The wife would even like that, crew cab. Doesn't look like it should have any problem pulling our camper. :grin: