Search results

yes, they don’t need to come out to be tested, just use a good source ground…

I realized i only listed the last 4 of the part no…the part numbers are 12340070 or 71 for fronts, rears are 12340072

the TM will always show front and rear shocks, but it not necessary to run them that way, Ive run 0070, 0071’s on all 4 corners for 30yrs, lately I’ve been using 0072’s….they are rears, but used on all 4 corners

You guys need to break out the schematic, the transmission and it’s associated components are all 12v, The input voltage at the Trans relay from the ignition is 24v, once 24v is presented, the relay closes, this forces the adjacent 12v relay to close and supply power to the TCM and Transmission...

yes

If your truck is pavement queen, the stock diffs is all you will need, lockers are for off road, if you use BTM “been using BTM for 30yrs” correctly, you have no need for ARB or E-Lockers.

AMEREX B500 5lbs ABC

A buck a mile is hard to come by these days….

Air in the fuel system, check all rubber lines, especially the water separator hose and all hose clamps.

Have you “rolled” the lights to determine it’s a bad lamp?

When you say “OEM” where did you buy them and for how much? Most are Chinese and blow immediately

Dang it, I was hoping the actual buyer came out to take his noodle flogging……

well, I have that same truck here in my shop I’d have sold you for $40k…soooo, yes

Once the pumps are introduced to ULSD Diesel, it’s a matter of time before the diaphragm gives up and it starts to leak from the seam. I keep a stack of pumps on the shelf, I only stock the AC Delco brand… not that I’ve found it makes a difference.

Model of pump is dictated by the model year…DS4 pumps didn’t make its debut till I believe 1994, so 1983-1993 still ran DB2 pumps in Civilian trucks, the 92-93 H1 has a DB2. DS4 pump is all ECM controlled for fuel management

Anyone buying an ECV and having owned and driven an A2 is going to be let down by the 3.08 gears… I still get about a call a week from some new owner or shop asking if there is a problem because the truck is Tac’ing so much higher than the A2 truck they own or owned. As far as REV and ECV...

An M998 already has the best gear ratio of 2.56, making it even lower IMO would “as it appears you have found” make it a slug at low speeds. The absolute best thing for an m998 is a 4 speed transmission.

The only way a diesel engine just “shuts off” is if the fuel cutoff solenoid is denied power or is faulty…I had a truck once that had a bad connection on top of the pump.

Personall, I’d lose the skins, the doors and truck look better with just the X-door.

KDS green label is not a “Smart start” box, it’s known as a single component EESS, they were short lived and suck IMO. they do NOT use a TSU in the water crossover, hence the “Single component“ name. The only box in production is the KDS or Nartron S3 EESS smart start system with TSU, this is...