Search results

One thing to consider, if that wire #74 was pulling all those amps it should show signs of melting, disconnecting and verifying is a good plan.

The wire 74 (pin I) will show very low impedance (resistance) to ground. I just measured one at 2.5 ohms If there was a short between positive and pin I it would try to kick the starter in when you connected the battery and would certainly cause a flash.

Welcome to the SS forums!! The most common things that can cause this are: Stuck check valves, if they have not already been removed then do so. Bad lift pump. plugged pickup sock in the fuel tank. When was the last time you changed the fuel filter? With the engine running if you crack the fuel...

Some radial movement is normal, the oil on the bushings is rather thick when cold and there is not allot of mass there so all that sounds normal IMHO.

Port Aransas TX

I think it would be next to impossible to keep that screw from leaking, was definitely an unwise move. The early TCM should serve you well.

Yes I think it was United Parts Service, it has been many years, 25 or so.

Welcome to the SS forums!!

What are the "receiver" looking mounts on top of the bumper with the thumb bolts for? I have seen this on another truck and was wondering.

I have never tried with the panel out but cannot think of any reason the trans would not work, at least to the point you can read the codes which would be next. The grounds for the transmission sensors should be grounded back to the TCM, looking at the schematics nothing is obviously dependent...

The first thing I do is make sure the trans light comes on when the run switch is put into run position, engine not running. If not unplug the wire harness from the glow plug TSU (temp sending unit) so more testing will not fry the glow plugs, passenger side of the front water cross over. If you...

I actually have the gun and mixing tips that I use to dispense potting material.

Are there any number tags on the wires connected to the switch?

I have been racking my brain on how to get some air to my feet on this install. The monster Fleece Turbo on that Duramax cancels any attempt to run a duct similar to the original on inside the doghouse. So I trimmed up the bracket used in the original Basic heater that has the hose that goes to...

I have had hell with ducting for my project, I purchase this duct a couple years ago and got home before taking it out of the box and seeing the upper and lower section had completely separated, I bought one last week only to get home before noticing it was missing a piece making it unusable, I...

They are completely different loops, the trans/transfer and diff has it's own loop and cooler.

The transmission cooling system has nothing to do with the power steering/brakes. That fitting seals on an O ring so movement might be completely normal.

The TCM-2100AB Etc. is a TCM built by PCS, it does not require a eprom but is rather expensive. You can use a reman TCM 609 but will also need to purchase an eprom Here is one source for the TCM609...

Is this what you are talking about? the gasket between the canister and the body? it is hard to make out, the picture does not have good resolution. It is better to look things up in the TMs rather than looking at a retail site, these are quite plentiful. 12338379 or 5330011880911...

I would think it should not turn so easy, you need to figure out where it goes and what it is connected to, the vid does not give much to go on.