Search results

Breaker protection like overloads?

put them all, that way when we jazz fingers on the googler we have all know numbers to search for, espically usefully for all the superseded numbers

This is what i have on the shelf for 804a, i think the 86472 and the 01-376-5666 are the same, but i dont remember for 100%

I will pull the filters when i get home for an 804a

Would that 4bd1t be the same as a 804a? Assuming the t is for turbo, 4 is 4 cylinder

Photos of motor would help

Good deal

Correct, will not run without mpu connected. Mpu controls fuel actuator did you check fuse by voltage regulator? Do not bypass fuse even for testing only.

Also check big fuse next to voltage regulator behind control panel

Correct, injector pump side of motor, mine needs adjusted, target is 2.5 to 3.0 volts

Did you check magnetic pickup? Have you tried bumping the start switch again after the engine is running? Also called modified start sequence.

If you are the only operator, run it forever bypassed. Heat is the important part

https://www.steelsoldiers.com/threads/mep-804a-intermittent-cranking-no-starting.192838/page-2#post-2269649 Read and test thru this thread

The rim offset for the dual is too much to go from singles to duals. Duals to singles is no problem. The dual wheel rubs on the springs before you get the thimble on.

Still no start?

Following, i thought i was loosing it, could find photo albums to save my neck. after some long learning curves, i like the new setup if my vote counts for anything

Follow up? Updated? Made it back west?

Yes, that is the only tm, did you attempt to clean and adjust? Adjustment is on page 0028 00-5 just dont forget its bypassed, if its only you operating it, i have no issues running it bypassed

If its bypassed, be overly overly cautious about keeping he box sealed up, if he box isnt sealed up, the heat exchanger can overheat and blow the end out, then you get flames and a big fan pushing the flames I have one in Montana that has ran for 3 winters now bypassed, but the heater never...

Clean it out, it get filled up with dust, then readjust, i think there is a procedure in the tm