Search results

Will that work?

https://www.ebay.com/itm/155282999311?hash=item242796880f:g:GIwAAOSw-8thw8rl

Also I have noticed some TSU units with same part number but different branding like (KDS) . From my understanding the brand needs to correspond. So a Smart Start box would need a smart start TSU?

I think I have an issue with my TSU. The truck starts right up from a cold start. If you let it run for 10 or so minutes and shut it off and restart the wait light comes on for a second then goes out. I go to turn it on it turns over for a little bit then finally turns on. I’m assuming that...

Haha the wire was cut when I got it. The yellow wire nut is temporary just to get it up running.

Old picture I have on my phone. But When I get home I’m going to confirm it’s there.

Attached is a picture of the generator. The tensioner appears to have good spring and the pulley is not loose.

I have a cheap one so I’ll have to set it to the lowest setting. Thanks for the great info.

I have a meter but I suck at knowing how to use it. Not sure what to set it to.

So I noticed that my temp gauge did appear to be working on my M1152A1. I tested the gauge by unplugging the wire at sending unit and grounding it to the engine. This made the gauge go all the way up and the over heat led to come on. That led me to believe that the gauge was good and the sending...

Also noticed that MacMotors has the belt listed at 112”. When cross referencing it via part number, it should be 114”?

Got a belt 12469149-3, 112" SN#s 196901&UP 01-488-5606. From MacMotors. Put it on yesterday…. Fail. The thing falls of after being on for 30 seconds. Tried multiple times and all fall off within 30 seconds. Put the old belt back on and dosnt fall off. My old belt seems to be higher quality with...

Built a dog house for 6.5 turbo out of 1/8 aluminum (old street sign).

Thank you!

I have been searching for the correct size serpentine belt. The belt on the truck has no numbers on it to reference and internet search has left me with multiple sizes. -2007 M1152A1 SN:252865 -6.5 turbo - AM General A/C -200AMP generator Attached is a picture of the a/c compressor. All my...

Thanks for the inf. Yes the it’s the switch. The truck runs fine, just can’t figure out why the wait light started to start blink.

Got a question relevant to cold advance. I put a new cold advance in since mine was broken. I put the new one in and on the new wires are both labeled 589. The wires from the truck are 589A and 589B. Since install my wait light flashes. It starts and runs fine. Not sure if the wires being...

Thank you!

I have an M1152A1.

Im almost 100 percent sure it’s electronic. I’ll will try to disconnect and clean and reconnect.