Search results

Not sure of the 90Deg fitting on the engine to the cable, can't find it in the TM's. If it is the cable jacket you might check with Memphis equipment.

Are you referring to the large line I have circled. This is the tach drive cable.

First thing to find out before going any further is does the owner have a transferable title for that truck with matching vin number. I wouldn't conceder it without a clean title. Next step would be to see if you can get it started with some fresh batteries and fuel. Nothing would ruin your day...

Nice looking trailer and good price. You just are going to have to get a deuce now to tow it around....:-P

Great looking CUCV. A few more pics would be nice...:)

Good luck and remember we are all counting on you.

Axle clamps for use with a tow bar.

You are correct in your thinking what the spec stands for. Your meter has FS=1AAC which means Full Scale deflection is obtained with 1 Amp A.C. The meter you have found has a different FS value. Full Scale deflection is obtained with 5 Amp A.C. Although it would work it will only read 1/5th the...

I would have taken time off without pay to watch a saturn V/Apollo launch. Oh well just wasn't born at the right time for that.

Did you check with Saturn. They list a kit but it might just use a standard flasher. Just throwing it out there. 0940

Glad to hear it was a simple fix...[thumbzup]

Sounds like a pretty good night there... :D

Correct. And when the wife is happy everyone is happy. :D

To make it a one man job I used a remote starter switch hooked to the “magnetic relay” and used a compressor wrench to fine tune the position of the rocker arm.

One easy check to do is verify that the plunger in the HH is moving when you crank the engine. Didn't see in your post were you checked that. 2cents

Having the time to do it I would much prefer to do a rebuild. That gives you the chance to magnaflux and check the rods for stretch and twist considering how they seem to love to try to escape. Also you can take the opportunity to mic the crank for wear and out of round journals and runout.

I use a very simple 55 gallon drum filled with water and 2 cheap 4500 watt water heater elements. simple and inexpensive.

Don't you hate when that happens....

But first I would have to buy a lathe and the raw stock so even at the current cost they are a good buy for some of us. 2cents

TM 9-2320-361-34, Sec 3-6. ROCKER ARM COVERS REPLACEMENT (Contd), page 3-17. Step 8, Tighten lockscrews (2), (13), and (10) and locknut (29)30 lb-in. (3.4 N.m). Repeat tightening until 50-60 lb-in. (5.7-6.8 N.m) is achieved. Does not specify any pattern but like Ray said above I also use the...