Search results

That is a 6 lug duece pattern not a 6 lug chevy pattern different pattern, wont work

Best just to get it hauled for that distance.

I don't even know of any dealers for parts for the trailers.

What is a Jr. Moderator?

That is an issue if you are using it as a dump trailer.

gimpy beat me to it. IT is a plug for the bellhousing. you are not missing anything. you put the plug in the hole when you are going to be fording

Be careful on the top end. If you have a valve stuck you will end up bending push rods, or having a piston hit a valve that is stuck down. I damaged a ford 272 but getting a stuck engine to turn even with the very slow a cautious method. The engine can be fixed with push rods and a new valve...

it's not really bad until you put the winch on the m109.

I have a few good trucks in Pa if you are looking for a different truck.

I will start a thread when i start the process with pics as i go. It will be a little bit until i have the time to do this. Plenty of pics will be taken.

I bought one of those prototype vehicles from GSA a few years ago. It is a M36E3. I offered it up here once or twice to the group if someone wanted to own it. My current plans are to bob it. I sold the bed and the rear axle. I have yet to cut the frame. the basics on the truck are as...

Do you have a list of the fittings and the hose lengths that you used?

Has anyone put m200a1 springs on a bobbed duece? I have a trailer that i was going use the springs from, but i also have a set of front suspension from another duece i could use. Looking for suggestions on which to use.

I also noticed that the hydraulic tank is not shown yet. It looks like another line still has to be installed from the valve to the tank and from the tank to the pump. Are you going to run a filter in the system? It looks good so far. very interested in how it works.

Did you use the stock (M35a2) winch mounting brackets and the frame extensions? How did the length turn out on the front end?

I bought a truck that had the middle leaf springs broken, on the main and the bottom were intacted. I think my truck was off roaded too hard. Not sure on yours though

I do believe there is this wonderful new classifieds section. You should try it some time.

I was directed to take a look at a NV4500. There is a very good thread about putting a 5.9 cummins in a a2. The transmission used is a NV4500.

No that would be a fair amount of work

Has anyone used a set of M200a1 trailer springs?