Search results

m38inmaine: What type of wood did you use, and what kind of paint etc. did you coat it with? Thanks, Bruce

Thanks guys, but I am still a bit confused. Acording to the TM10-5411-205-13, the M1028 requires dunnage as described in TM 9-2320-289 which is the CUCV set of TM's. I've looked in those and haven't found any description of dunnage for the M1028 and S-250. I know I can improvise but I was...

Would you please post the TM# and page for the cribbing for the CUCV. The reason I ask is because I have searched thru all the cucv tm's I have and did not find any info on cribbing Thanks, Bruce

I couldn't tell from the pic, but the first one looks like the side is a seperate piece. The reason I notice this is because I have an s280 where the side is made from two panels that are hinged to fold down and form a floor. Bruce

Wow! Thank you very much! Bruce

I also have an M720 and hope to do the same eventually. How do you expect to get it licensed? I would be very interested in the details of the conversion. Thank you very much! Bruce

Well that is a relief, I was beginning to doubt myself. That is terrific that you got it figured out. It is nothing to do with old age. It is our duty as adults to keep the younger whipper snappers guessing. Bruce

What is your current status with this project? Bruce

I am making the assumption that you hav tested the starting relay coil and contacts. The above does not completely eliminate the suspect wiring but I didn't want you to have to cut the ppl/wht wire, just splice onto it. In the unlikely event there is a possibility that the circuit has a ground...

If you are getting an open between the point where the yellow wire attaches to the starter switch and the ppl/white wire where it attaches to the starter coil, You can unplug the starter relay to make that measurement, then , after pluging the relay back in, temporarily splice a wire onto the...

Thanks to all who responded! Bruce

I figure the answer is no, but I have to ask. Is it possible to get a Multi Fuel or diesel engine set up so that it will run on propane or natural gas? Bruce

The brackets in the classified are for the M884, not the M1028. You need 2 brackets that bolt into the bed to reinforce the ends of the sides, and one long channel with U bolts on the ends that goes across the top edge of the forward end of the bed. Bruce

Based on what Warthog said, It looks like a bad ignition switch. I don't know for sure though. Bruce

Thanks, so group 31s will fit with out having to modify anything? Bruce

To be honest, I did search, but after going thru about 50 threads, I didn't find what I was looking for. I then started just going back thru the 5 ton threads to about page 25 with no luck. I Try not to be a PITA, but I guess I didn't suceed this time. Sorry for the hassle. Bruce

My 6TL's need replacing. Can anyone reccomend a really good commercial battery that will fit and wont cost an arm and a leg. Thanks for any tips! Bruce

I am noty sure, but I think the source comes from the ignition switch. My guess is that the water in fuel solenoid and the glow plug module act in some way to inhibit the signal by breaking or inserting ground. I hope I have been at least a little help in this. Bruce

If you look at the legos connector, you will see a mirror image of it just to the left. The wire then goes to a two pin connector with a diode plugged into it which id probably on the firewall in the engine compartment. Then it goes to the "water in fuel solenoid" in the fuel filter block.It is...

I am also looking for NSN's or part numbers for a 1 1/8" pin that is for the ends of another tow bar. The working length is 3.6". ie the portion that goes thru the towbar end but does not include the length of the head or the portion that sticks out the other end and has a hole in it . Thanks, I...