Search results

anyone? maybe just a pic underneath your rig of the general area ?? Thanks

Getting ready to toss the 3l80 np218 back in but can’t seem to get a good look in any of the TMs for the cooling lines installation.. Can anyone assist me in which one goes to upper line and which goes to lower line ?? My thumb is on one line and index finger on the other... Does it matter...

I think my cover plate underneath has a hole in it with a plastic bung stuck in it.. Remove plastic bung and I believe it has access to that nut /washer.. If I’m not mistaken that cover piece is fairly thin, you may be able to drill an access hole and use a plastic hole cover when done...

hmm.. that would be it... now to find one.. looking found Kascar and I'm sure many others have something , just search for that ID number and I'm sure you'll get lots of hit.. here's one 12338950 Latch, Hood, Vehicular Engine Cover Not and endorsed spokesperson😂

Have been putting this off for 5 months... First time pulling plugs and replacing... 8 out, none swollen 🙌🏻.. took 30 mins👊🏽 Wire brushed those first two... don’t look bad at all.. new plugs in tomorrow

Been waiting for a "MODS" section. Nice to be able to look at others work and maybe get some own ideas about projects. Thanks for getting this going.... Ocho

Hmmm.... those appear to be very much alike/functioning as a “cinching tie down”. Bet you could make these work possibly ..

😥😥😥😥😥😅😅😅😅😅😆😆😆😆😆😮😮😮😮😮

six one way, half dozen the other.. but make sure to get eight. 🤣 ... Any "non-swelling" plug would be fine I'm sure. Make sure its for a 24volt system.. They will have a bullet tip versus a spade connector. Spade is for 12volt systems... Wellman I believe makes a decent plug.. You can...

Corona has kicked in... The isolation is real. Excuse my rant..

all of them

hmmmmm...confusing to say the least,,,

Cleaning up my M998 Generator. Cleaned up well but several cracks and pieces are missing from an external band. Not sure of material or importance of this “band”. Anyone have any info on portion of Generator shown in this picture below. My generator is missing most of this coating and was...

IN

Just picked up 2 on ebay.. Pm me if you want one for half listed prices,,, Ouch

Umm no, Kas has em at $129... Id clean if possible.. Ouch

working? id say $699 would be great price... but haven't had to buy one yet... Looks good with temp sender and bonus plugs

Im sure WireFox probably has that info....

just put em at 30-40lbs of pressure and either like the ride or not.. up--stiffer, lower--softer... like any other vehicle.. just my 2 cents