Search results

Not sure how that would work to be honest. I know my 003 has the 72-5020 and a WebFLIS search on the 72-5338 came up with NSN: 6110010957440...

The board labeled 72-5338 is listed for a 400hz unit. REGULATOR,VOLTAGE - 400 HZ 72-5338 (30554) 332-2285 (44940) The 72-5020 is for a 60hz unit. REGULATOR, VOLTAGE-60 HZ 72-5020 (30554) Both are AC vr's and are the same for the 003 and 002.

Nice to hear all went well. Take your time and give it a good going over.

I won't be able to help but I wish you well on the pickup. Be sure to check the brakes for fluid level and operation.

Check my link above. On the menu on the left side of the page is the link to "MERDC Camouflage Templates", about halfway down are the templates for the M35. m35a2-01.gif & m35a2-02.gif.2cents

Might want to try this site. Gives color codes and layout. MERDC Camouflage Illustrations - merdccamo

1/87.5 to be exact. :D I have always loved steam locomotive, 1 : 1. Thought about scale steam but beyond my bank account. :(

Welcome to the site. Hope you get the info you need. Also incase you haven't run into it yet you might check on Military MEP and Aircraft Gen-Sets - SmokStak

Nice work. [thumbzup] I need to get one of those armored interior lights for my deuce. I don't run much at night but there has been a time or two I could have used one.

The red button is a reset/relief valve. If the piston in the motor assembly jams to one side and stops moving you can push in the button to relieve the air pressure and move the manual arm to get the wiper running again. The button should pop out on it's own. The theory was you could do this...

Ding, Ding, Ding we have a winner. Nice deuce you have there. [thumbzup]

Congratulations on the new deuce. No pic's though. Sorry, but I had to. nopics

Nice ride. I wouldn't mind some wheel time in that.

That reminds me I need to split some wood. Nice pic's. :driver:

I have seen some like that before. I have given some thought to moving my two inboard hooks. The position of mine cause the back flap to bulge out because the hooks are offset from the cords. That's the way it came from MONG though.

Here's mine.

The VR for the battery charge circuit is available. Just had to change mine because it would over charge the batteries. Voltage Regulator/Rectifier (Battery Charging) For Onan MEP-002A / MEP-003A 5KW and 10KW Generator Sets, FVR4006

Are those the shops over by the Obrien & Simmond street area.

You got to figure they wouldn't miss just one... :whistle:

Man that is a big recovery vehicle.