Search results

I am going to use a spray in bed liner. The bed somewhat rough and I think the liner will make it look better. The stuff I got is suppose to be the correct green, I'll post pictures when I get that done I also have the troop seats I will be installing back on... or at least the sides. I need to...

Funny, I heard on the scanner someone with a siren was chasing people... At least that what the Washington State Patrol was saying... Somewhere on SR3...

Replaced the u -joints on the front drive shaft. The TM makes this sound easy... I was cussing like a sailor trying to get the shaft out. Ended dropping the sway bar... took most of the day but all replaced.

THANK YOU!

Thanks! Funny they are not the same on each side. Looks like the B pillar is off by 3/4 of an inch

I have all the hardware and fastener for the top install. I am looking on where to drill the windshield frame and B pillar to install the rivnut tings. The B pillar is new with no holes. The windshield frame has holes for the location of the twist fasteners but no hole for the rivnut. Item b...

Looking for parts for the bottom latch on the boor. There's a thing (number 14) that I can not find. So time to make my own. This is the first time I used fusion 360 and I design up a part using the dimensions from here . I will 3D pint the first draft to see what it will look like. I will also...

Wow no one has any info?

I sent you an email...

I am installing a soft top on my M1151 and have a question. I see there are location holes for the weather seal the thumb turn things fasteners on the windshield frame. I don't see location holes for the side rails to install the rivnut. Also I have a NOS B pillar and don't see a location hole...

Wet side (noted by rain drops on steps) If you are in Everett I am just East of you in Skykomish valley (East Snoho county) Is yours the one that was on Facebook market place in Woodinville/Bothell? There was also one seen on a trailer in Monroe. or is yours another. There seems to be a few up...

They are hens teeth but I found one. Maybe you can take a pattern off the one I have... https://www.steelsoldiers.com/attachments/hen-thooth-jpg.913850/

Did some more work on the doors... I think this will do. Just need to put some reflectors and the door hold open things

More done... Primer, insulation, Interior skin and paint.

They demill by cutting the radio power cable, first pic... Then remove all fording plumbing... 2nd pic is where your Froding CDR was cut out. 3rd looks like the connector for fuel pressure sensor on fuel filter. They take the bolts out and drop the fuel filter. They do this to get to the fording...

Getting there... Nothing is square on the box but the sheet aluminum is... Have the gaps within around 1/16" (aboot 1 and a half M&Ms for non inch people)

Slowly but surely... The Weather isn't always ideal here in the northwest. I don't like welding in the rain or wind... Here is one of the doors with the skin attached...

side to side

Anybody know the size they are? I would like to make some for the rear doors . Or maybe a place that I can buy them?

3 color camo