Search results

You study and offer whatever it is You want to pay to the seller that does not necessarily have to sell that thing. That is the IRS definition of a vehicle deal. Anything bewtween a buck and 15 thousand bucks. Go see others that have them. Make a deal.

Just examine Everything. Same as one would do with an old Accord or Caprice or Ram or Ford Interceptor or MGC. It is now up to You to preserve Her and make it better. What the heck has she been thru anyhow. Work, Work, Work. Hey, You picked Her so now fix it, like being married..

I would replace it with Swagelok tubing, not any kind of hose. Would use SS-T8-S-049 with the two fittings would be about 40 bucks and it will not fail.

too much really good inforamation in here so I make comment and it allgets saved I hope. ?

Hey, ......................what do I know But I know what I would do.......... https://www.steelsoldiers.com/threads/survey-oil-line-of-death-3116-governor-oil-feed-line.191478/page-3#post-2250909 I would replace that stuff with SwageLok. If ANYTHING happened to make a LEAK anywhere...

If you don't use a side guide handle then you should with your cutoff wheel machine. It should be a 1/4-28P? hole on the side and I put a Snap-on chisel holder in there. I post this as you do nice work and WE don't want hurt. Whatched a guy cutting off an engine mount almost run the wheel up...

can you post that same second photo with the hook but with the full nomeclature sticker to read, Please.

Just plug the line inverse fitting cheap even NAPA used to have them

Does your engine have cylinder bore liners? What is recommended by engine manufacturer and the TM's for that truck?

https://twoifoverland.com/m1083-repair-maintenance-costs/

foods for thoughts https://www.steelsoldiers.com/threads/cat-3116-lost-oil-and-started-knocking.191430/#post-2244561

Don't know if this will help but it is there.

https://www.steelsoldiers.com/search/336474/?q=driveshaft+phasing&o=date search is your friend........... http://www.mtpdrivetrain.com/fmtv-support/

I put a piece of rubber to act as spacer for the doorjamb latch. That tightened it up whereas door catch had "more" to catch on, worked good.

Over 20 years of dust is impressive.

Ask for a real in-tank Bradley/Parker pump from your friends on here. Perhaps someone will part with one for you. There was hundreds of them and the SS bought them all up from the eBay. Install that and put a real fuel system filter on the truck, 3 micron and up, Your choice, then no need to...

hacksaw

3-904 NBR 90 As the name implies, these O-Rings are used to seal Straight Threaded Tube Fittings. ... Straight Thread Tube fittings are often used in relatively high pressure applications, so most often a 90 durometer NBR or FKM O-Ring is specified. Nitrile rubber (NBR, HNBR, HSN, Buna-N): a...

Say you gonnah keep her for yourself and descendants forever and let that be your guide. ...... B Mikes stuff is $$$$ The "dust boots" are dust boots and not meant to hold in grease. Follow the TM and remove the plug and let the nasties goes OUT. There is many multiple maybe hundreds threads on...

gringeltaube comments with the wire is good and the engine oil vs the silicon grease too. After changing hundreds of filters on jet engines {heats locks them up as per design} so I drove my square drive screwdriver thru the bottom or side {lowpoint] to drain and once thru both sides to get...