Search results

I can not get them threaded to the block on my m1008. They won't even thread to themselves... Is that right? I've seen folks with good success on here but I can't even get them started! I'm using the same part numbers as listed here in other threads.

Subject says it all. 1986 M1008, added electric fuel pump, spin on filter, doghead mod, added 2" receiver, lifted 5" using ORD shackle flip and tuff country ez ride springs, obviously H1's with 37" GY's…. has a new th400 in it. 52k Miles. Interior is decent, the seat has been recovered, the dash...

I went out to diagnose a hard start from this morning. I planned on testing the glow plug relay but the engine was too warm for to keep cycle the relay… I think… So I decided to look for fuel leeks and noticed the side of the IP was wet. Looks like there may be a small leak around the throttle...

I have about 500 miles on this one. From what I've read it could be a few things. A bent read drive shaft? Mine has a pretty good dent in it. No braces on the transfer case. Worn out front shaft U joints. I have had it in 4wd twice in my yard pulling out stumps, that were no big deal. The...

I'm going to be doing a short term durability test on Behr. The canopy pictured was painted and left to dry in my garage for three weeks. The average temp was probably around 60. The truck has original carc from 97. The tailgate was painted with, from what I can tell, rattle can Camo paint. My...

I just picked up a 1986 M1008. It did cold start really fast, faster than any vehicle I've ever owned. I ran it just for a few minutes one day and then the next I had to crank on it for nearly a minute before it would light. Once it did start it ran flawlessly, and restarted as it should with...

Hey guys first post, i just picked up a 1986 M1008. I'm planning to put H1 wheels and tires on it. I'm good on the lift portion, its the wheel spacers that scare me. I've always heard they are bad news. I've done a bunch of searching on here but the conversation of steel vs billet aluminum/...