Search results

Mweiss wrote: Hi Rich, received the gauge today and installed it. Unfortunately, still the same result. Barely moves when the battery is charging. There is only 2-5mV across the gauge (an amp clamp on the battery cable shows more than 8 amps going into the battery), which indicated to me that...

Is there a fuse on the control panel back wall next to the A1, (Volt Regulator) and is the fuse good if its there.

There are more models than grains of sand on the beach. I think you need some paint remover. NSN: 8340-01-533-5396 Ser, # N26-11899-001 (I think) Model # HP-2

Do you know the TM number for it? I have a lot of COMMO and RATT Rig TM's.

Chucky's back in town!

Can I vote twice?

Most had the engine ripped out and the rest went to the shredder.

On several sets I found that the Short Circuit fault light on, and it was the wires to the burden resisters in the left rear corner of the control cube. They had worn through, due to vibrations, against the side of the control cube. I like to look for shorts by opening all doors and take off the...

Well, its better to have, and not need, then to need, and not have. Sure you can do that. But if for any reason later on in life you need 3 phase, you will not have it.

I saw lots of that here when the goats and jeeps went away. We had a DRMO and Can. Point in K-Town. Drmo in Nürnburg. DROM in Böblingen. Most of it went to Holland

ryoung, You need 10 more posts before you can PM.

You wrote: I did this test last week and read about 2mV across the meter. Started at 4 or 5mV then settled to about 2 mV. I didn't buy this at auction. It was not cheap. I spent a fortune on it, with the understanding that it was fully functional. There was a cheaper unit nearby to me, but the...

c. Set multimeter for DC volts and connect across BATTERY CHARGE ammeter terminals. Connect positive lead to positive terminal and negative lead to negative terminal if you observe or think battery is charging. Multimeter should indicate up to 50 mV (25 mV equals +10 amps on BATTERY CHARGE...

Germany is no better. Do a mod on ANYTHING that moves, and "You in a heap a trouble boy!"

Thanks!

Post this picture in the TM upload forum. Explain what it is. And what its for. This is something lots of folks will might want to see, and to hide it here in this thread is a crime. No one will ever find it again. Thanks!

High humidity and water in the fuel are what kill the strainers.

Mrgior wrote: Starting a thread for the specific wiring issue on the modification page would have probably had more traction as well. This is really key in getting help. Start a thread on one problem. The Title is very important. People who are M880 fans key in on a Title like, "M880 starting...

You could start a "Parts Wanted" Thread.

This is a not uncommon failure. Most of the time, if you look into the gen set, under the removable cover, Item #5 you should see a small, (or large) pile, just like in your pictures. MEP-804A Diode Ring Destroyed Read this thread. Its long, but will help. ALSO, start a parts wanted thread...