Search results

Try username storeman here on SS

Keep in mind mine is a H-81 almost the same. Mine did not have any soot on start up nor has it had any since. My switch will some times go past the vent selection at 3 o'clock and end up a 4. But I just give it a little twist towards the 6 o'clock and it pops right back. Mine runs about 100 to...

Will this help you http://search.yahoo.com/r/_ylt=A0oG7iC5H7FS1XwACEVXNyoA;_ylu=X3oDMTE0ZnM4MmttBHNlYwNzcgRwb3MDMTEEY29sbwNhYzIEdnRpZANWSVAzMjdfMQ--/SIG=138s446v3/EXP=1387368505/**http%3a//www.dtic.mil/cgi-bin/GetTRDoc%3fLocation=U2%26doc=GetTRDoc.pdf%26AD=ADA423973

The best answer to give is too check the TM, that way you know for sure!

Mine is from NAPA and has been in for two years with no problems.

Subscribed.

I have a H81 heater I got out of Ft Knox, only had one hour on the meter. Finely fired it up to day for the first time. After spitting a few time to clear the air in the lines, it ran like a champ. Ran it for about an hour no problems. Very happy camper here!

This may or may not help but what mode is the phase switch in 120 only 120/240?

Lube order Order attached

Shift issue My M1009 has an issue shifting also It shifts fine on first startup. If I shut the truck off after restart it does not like to shift into 3rd gear. I can manual shift from second in to 3rd and it shifts. After that it will shift fine the rest of the drive. But if I shut it off it...

Filter chart Attached is a chart for 1-14 thread filter head filters

Saw a 16D in Indy go for 2370.00, may have been an error but that's what it showed.

Everything I have come across has been 80's & 90's and then I found one dated 75. I thought it mite be a miss print. Thanks for the help

Sorry I though it was one program covering all of the MEP family. I am looking at the MEP002A & 3A group. Thanks

What years were the MEP gens produced ie first year? Thanks

Your post in the classified section in no longer there!

Did your units come with the heat and return duct? If not were did you get them from? Thanks

Do you have any lift on the truck?

When I first got my M1009 I would run a quart of 2 cycle outboard oil per tank full. The truck ran better and was quitter. Now I run Standadyne fuel additive at every tank full for lube. Mixing Used motor oil or running bio-diesel is at your own risk. I worked in a pump shop and bio-diesel if it...

American Bosh Your pump is a early American Bosh which became Ambac later, see attached.