Search results

Looks great! What model truck is the Gemtop from? Does it fit well? Tell me about the stove..............

Plum this in with quick connect fittings and hang it on the outsidre of the trailer. Would work great with a shower on the back deck. http://www.overstock.com/Sports-Toys/Triton-On-Demand-Hot-Water-Heater-Shower/4018344/product.html

http://www.expediter.com/pdf%20folder/B%20folder/B7.pdf http://www.etrailer.com/dept-pg-Trailer_Hubs_and_Drums-sf-Hub.aspx contact etrailer.com when you get the trailer, see if there is a serial / model # for the spindle you have.

The M1102 has torsion axles so you will need to find the axle mfg and see if the offer a hub that fits the spindle that has a 5 x 5 pattern. The trailer is wider than the jeep so watch your side clearances. Here is a diagram with measurements and a picture behind a jeep. Good luck on the pick...

Thanks, Love to see others ideas and builds. I look forward to the work. Are you also on Expo? Keep us posted.

Great work on the transformation. I like your coupler set up. Pull the pin and it is theft proof. Rear receiver is a plus for racks and tandem towing. Wire it with a trailer plug when you do the lights. What bolt pattern are you running now? Did the axle come with lower shock mounts? What are...

Save it, Very cool with the douple ended tailgates. I have seen worse reserected. Take your time and as money permits clean it up. As for a landing leg, get a newer crank version and make it useable.

The axle on the trailer should be a DEXTER youmay be able to swap the hubs out for a 6 blot toyota pattern. Same as the 1/2 ton GM but I believe one is hub centric vs lug centric if it matters.

Looks good, My truck is lifted and I use the top hole for the coupler. I like the extra length you have below so if you tow with a lower vehicle, You don't need the TOWER OF TERROR receiver to hitch it up. Keep us posted on the results. Did you list your surge assembly yet? I sold both of...

That would make an excellent camper. " like a tear drop" Center section removed, interior insulated a custom matress, and a removable chuck kitchen. Nice find.

http://www.mainetrailerregistrations.com/

I replaced my chains with safety cables and snap hooks. I cut the mounting tabs off for the correct angle on the 101A2 but like the way I did the 116A2 better I used two short bolts and nuts on the single nose bolts, instead of the long pass through. " no need for an angled spacer." Sold both...

Progress looks good, I cut off the landing leg on my 101A2 and replaced it with an tongue jack from Harbor Freight. it is adjustible and works but the original landing leg is better. My 116A2 I left the leg on. You can remove the backing plates and shoe assembly as I did but it only drops about...

Nice score and a great price. I removed the brakes from mine and it pulls and stops fine behind my 2500hd. Use an impact driver " hammer on type" to remove the screws. clean and grease the bearings and you are good to go. My build where I removed the surge system...

m105, M1102 and M101a2 side by side.

Something to cherrish. Very nice.

Pictures please.

Funny how the proper documents don't matter for some BIG things? But to pick up a trailer is a no go!

Check here for some great builds. http://www.expeditionportal.com/forum/forums/42-Expedition-Trailers

Nice find! Those are some tall stake sides.