Search results

If I had something to nominate, sure would.

Try this. Press the put the S1 in the run position. Press the reset button on the A2, and hold it in. Dont let go. Start the set. If it keeps running, flip up the S7 and then let the reset switch go. Keep running? If so, and idiot lights?

This is the one I learned on. Destroyer. REFORGER, 1974.

The scoop loader was used for this one!

That wrecker sure brings back the memories.

The Flim Flam Man strikes again!

Maybe I need to steal a truck, so I can enter it here.............................................

Mr Pope has not been in the forum since his last post.

Look at the fuel tank cap. See if it has a little valve in it. it will be in the inside of the cap. If its closed, the fuel tank will not "Breath". It in affect, creates a vacuum in the tank.

Put a known good A11 into the generator that will not make voltage, all the time. Fire it up. What happens? Notice, while starting, do the AC volt and hertz meter come up a ways, and drop down again? Or do they not move at all? If they move, then you are getting initial excitation. That means...

I forgot all about this thread.

I assume, always a bad thing to do, but assume you have used the hand pump to pump fuel up to the IP? And assume you have cracked the injector line farthest from the IP, and turned over the engine to force out any and all air in the fuel lines? Crack the return fuel line, after the check valve...

F1 and F2 are on the left side, inside the rear door. There is a terminal strip there TB16. Should only be 4 wires to it. Two in, two out to the main gen.

Yes I did make a mistake! And kept referring to it, instead of looking at the wire diagram. I did just check the back of my A5 card and a solder strip on the back of the card was not good. I fixed it with solder and should work. The rest of the card looks great. One more note. When I start the...

Walker, What you need to do is stay in your own thread. This thread is long dead. First off its against forum rules to post your problems in more then one thread, and second off, you have no idea if your problem has anything to do with a problem someone else is having. AND you bring confusion...

Walker, What you need to do is stay in your own thread. First off its against forum rules to post your problems in more then one thread, and second off, you have no idea if your problem has anything to do with a problem someone else is having. AND you bring confusion to someone trying to solve...

If the Presice set is a MEP-105A, NSN 6115-00-118-1252, then yes it will.

When you put the A11's in, you don't even need to bolt them in. Just slide em in. They are grounded through the wire harness. Make testing faster.

Do what Ray suggested first. PROVE the A11's are good, on a set you know works.

Ray wrote: Have you tried swapping one of the exciters back into the previously "Good" generator to verify that both exciters are in fact bad? Perhaps something else is going on with the one exciters into and the exciters are not really the problem? After trying both exciters in the gen set you...