Search results

The A1 winch truck that I have did not have a tach. I believe this is due to electronic engine rpm control. Less operator options.

On the bell housing is an engine speed sensor I have been doing some reading up and this input is also used by the ecu.

Probably piggybacks off the trans harness somehow. The manual dosnt show a different harness for winch trucks so there is a good possibility the connection you desire is tucked away somewhere in the dash or behind the heater. Pic below is what the connector should look like. A tach signal should...

The self sealing tanks are MRAP. I dont believe you could cut one of those tanks down and retain the self seal feature. They are tig welded aluminum inside with special coatings. If you want a small aux tank one of the M931 tractor tanks are a bit smaller.

I am still learning about these trucks. If there was a theory of operation TM with a schematic of the whole truck it would make the process much easier. I didnt know the tps was only used by the the trans computer until recently. Since the IP is mechanical I am wondering if the ecu expects a...

Door strike 12417479-001 Door catch 12417475 Door catch 12417476 Handle TV990017 Regulator R 12417705-001 Regulator L 12417706-001 Handle 12417493-001 Handle 12417493-002

I just looked the power switch looks the same as most of the others. The zigzag lines legend pops out and will go in another switch. Swap it with your rotary warning switch for now. You can search Britax 511 on the net or auction site. Look here...

Nice. Once it warms up here theres alot of stuff I want to do including power windows.

If the light flashes and your truck shifts funny then replace the speed sensor on the underside of the transmission. Its an over the counter Allison part. 29543432 there are a dozen or so alt part numbers listed in parttarget.

I was thinking more along the lines of a 4bt I have been keeping my eye out for a cheapie non runner

I have learned that the trans control also uses a throttle position sensor on top of the engine its a small box over the fuel filter with primer button and has a cable running up to the IP. This with the sensor on the trans and it works together with the ctis controller. If you are in a lower...

Is it physically damaged? Cage it the bolts should be on brackets. Unless you are good with spring brakes I suggest paying a heavy truck shop to fix it. Spring brakes can be very dangerous.

The knobs get bent and stuck. If it makes heat you know coolant is being circulated. If the coolant level in the reservoir behind the cab is ok and the truck dosnt overheat then I think you are good. You may be able to take the heater apart and free the controls up. I don't have any message...

I have new floor mats for the main section. Little stuff like small ctis parts hoses elbows, door parts like latch strikers, window stuff and misc switches guages can be ordered. Odd stuff like door panels and sun visors will get expensive that stuff needs to come from parts trucks. Most engine...

They are very similar to some of the Volvo truck switches. The parts tm will show numbers. You can search parttarget with the part number or nsn it will list manufacturers and some may have multiple part numbers from different makers.

The battery side has 2 power cables going to the batteries. One for 12 and one 24 volt. The truck side has 12 and 24 volt leads making their way into the truck. Does your heater not have power or no circulating coolant? Very important to go over the power panel and make sure it's properly...

Most of the little parts are in current mil inventory and can be ordered but most of it is price prohibitive unless you really need it. I had looked into ordering steyr parts at one time they were at bit cheaper in quantity but with the international shipping the price ended up being about the...

Moisture gets in and corrodes them and then the rubber flap dosnt have a smooth surface to seal against. You can remove the valve and there are 4 nuts and bolts that hold it together. Best to have a spare on hand before tearing into an old one though. Just in case.

it sounds the the batteries don't have a good charge on them. Did you remove them to charge or charge in place? If you removed them sometimes a loose batt connection will cause headaches. There are things that will cause your truck not to start is the trans ecu is not happy. In the relay panel...